A practical reference on DAC: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2025-11-20 and is reviewed periodically as new material appears.
Laboratory handling centers on minimizing exposure to water, heat and oxygen before use. Working solutions are typically prepared in sterile water or a mild buffer, and any residual particulate matter is removed by filtration. When the powder dissolves slowly, a small proportion of acetonitrile or dilute acetic acid is sometimes added as a co-solvent. Containers are kept sealed and desiccated between uses. Records of lot number, reconstitution date and storage conditions support later comparison of results across experiments.
Identity and purity are established with reversed phase high performance liquid chromatography coupled to mass spectrometry. The chromatographic step separates the target peptide from truncated sequences and deletion products, while the mass measurement confirms the expected molecular weight to within a fraction of a dalton. Because the two common variants differ by the presence of the linker, mass alone can distinguish them in the unconjugated state. Amino acid analysis and peptide mapping are used when sequence level confirmation is required.
Reconstitution is typically performed with sterile water or bacteriostatic water, added slowly against the vial wall. The resulting solution should be clear and colorless; cloudiness or visible particles suggest a problem with the material or the diluent. Once in solution, the peptide is less stable than the dry powder. Refrigerated storage at two to eight degrees Celsius is common for short-term holding, while freezing aliquots is described for longer periods.
Purity is most often assessed by reversed-phase high-performance liquid chromatography, reported as a percentage of total peak area. Identity is confirmed by mass spectrometry, which yields a molecular ion consistent with the expected sequence. Amino acid analysis and peptide mapping provide additional characterization. Reported purity values are method-dependent, so figures from different laboratories are not always directly comparable without details of column, gradient, and detection wavelength.
Peptide degradation proceeds mainly through hydrolysis, oxidation of methionine, and deamidation of asparagine or glutamine residues. The maleimide group on the albumin-binding variant can also react with thiols or hydrolyze in aqueous media. Because these pathways accelerate with temperature and pH extremes, handling conditions strongly influence measured stability. Stability data in the public literature are limited and often generated under differing conditions, so general statements about shelf life should be read as approximate.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off white powder | Typical lyophilized form |
| Water solubility | Soluble | May need a small organic co-solvent |
| Purity assessment | Chromatographic peak area | Most certificates report a percentage figure |
| Storage temperature | Minus 20 C or lower | Dry, dark, sealed container |
| Identity check | Electrospray mass spectrometry | Compared against theoretical mass |
Naming in this area is inconsistent, and readers should treat product labels with care. In much of the literature and in vendor catalogs, the unqualified term refers to the albumin-binding version, while the version lacking the DAC group appears as modified GRF(1-29), mod GRF(1-29), or the same name with a without-DAC qualifier. Because one abbreviation has been applied to both materials, the only reliable way to identify a sample is to check the stated sequence and the presence of the linker.
CJC-1295 is the name used for a synthetic peptide modeled on growth hormone-releasing hormone, the hypothalamic signal that prompts the pituitary to release growth hormone. The compound was described by a Canadian drug discovery company in the mid-2000s as a long-acting research tool. Two closely related molecules share the name in practice: one carries a drug affinity complex, or DAC, group, and one does not. The distinction matters because the two behave differently in circulation.
The peptide backbone corresponds to GRF(1-29), the first 29 residues of native growth hormone-releasing hormone, which retains most of the receptor-activating activity of the full-length molecule. Four substitutions distinguish the analog from the natural sequence: D-alanine at position 2, glutamine at position 8, alanine at position 15, and leucine at position 27. These changes slow cleavage by dipeptidyl peptidase IV, the enzyme that degrades native hormone in plasma within minutes. The outcome is improved enzymatic stability combined with a still brief residence time when no additional modification is present.
Stability depends heavily on physical state. A lyophilized powder kept dry, desiccated, and shielded from light typically holds its integrity for months to years at minus twenty degrees Celsius, and longer at minus eighty. Once dissolved, the peptide becomes far more vulnerable, since peptide bond hydrolysis, oxidation of susceptible residues, and aggregation all proceed faster in solution. Buffers near neutral pH are generally gentler than strongly acidic or alkaline conditions. Repeated freeze-thaw cycles and exposure to air-liquid interfaces during vigorous mixing cause losses that are easy to overlook.
Verification matters because research peptides vary widely in quality. A certificate of analysis is only as reliable as the method behind it, and a single chromatographic trace reveals little about counter-ions, residual solvents, or water content. Independent laboratories commonly pair mass confirmation with chromatographic purity and, where relevant, quantify water along with acetate or trifluoroacetate content. Reported purity figures are not standardized across suppliers, so a stated value such as ninety-eight percent is not directly comparable unless the analytical method, column, and detection wavelength accompany it.
Characterization of this peptide relies on a small set of routine techniques. Reversed-phase high-performance liquid chromatography separates the target from truncated or oxidized by-products and yields a purity estimate when paired with ultraviolet detection near 214 nanometers. Mass spectrometry, either electrospray coupled to liquid chromatography or matrix-assisted laser desorption, confirms that the observed mass matches the value calculated for the expected sequence. Amino acid analysis, and enzymatic digestion followed by fragment mapping, are used when the sequence itself rather than the mass requires verification.
CJC-1295 is a synthetic peptide analog of growth hormone-releasing hormone, constructed on the 29-amino-acid fragment designated GRF(1-29). The name began as an internal development code during the 1990s and later spread through research supply catalogs and discussion forums. The molecule does not occur in nature; its sequence is engineered rather than isolated from tissue. Two related compounds are sold under this single label, and they differ by one appended chemical group that strongly influences how long the peptide remains in circulation.
The dividing feature between the two forms is a maleimide-based drug affinity complex, abbreviated DAC. In the DAC-bearing version, a linker attaches the peptide to serum albumin after administration, and that association slows removal from plasma. The version lacking DAC appears in catalogs as MOD GRF(1-29) or tetrasubstituted GRF(1-29). Because informal writing treats both as one item, comparisons drawn from such sources routinely blend measurements taken from two molecules with substantially different behavior.
===== Rpn10 ===== Rpn10 was the first ubiquitin receptor identified on the proteasome. Rpn10 has a von Willebrand factor type A (VWA) attached to either a single Ubiquitin Interaction Motif (UIM), in yeast, or two UIMs in higher eukaryotes. The VWA domain binds between the base subcomplex and lid subcomplex of the 19S RP, while the UIM extends into a space over the AAA motor, though the UIM has not been seen in cryo-EM structures. NMR studies have shown that the UIM of Rpn10 binds mono-ubiquitin, and K48 di-ubiquitin with higher affinity. More recently, the C-terminus of Rpn10 in higher eukaryotes has been shown to bind an E3 ligase, UBE3A/E6AP (see Proteasomal Ligases).
electron magnetic dipole moment Also electron magnetic moment. The magnetic moment of an electron, caused by the intrinsic properties of its spin and electric charge, equal to approximately −9.284764×10−24 joules per tesla.
==== Officer of the Order of the British Empire (OBE) ==== Civil Joseph Martin Chow Sun Yau, . For services to the Business and to the Community. Abdul Wahed Mohammed. For services to Education, to Business Development and to the communities in the National Capital District and Central Provinces during Covid-19. Chan Wing Onn. For services to Business and to the Community.
The Doctor of Clinical Laboratory Science (DCLS) is a professional degree in clinical laboratory science in the United States for medical laboratory scientists. The DCLS is board eligible and qualifies as a CLIA high complexity laboratory director (HCLD). Doctors of Clinical Laboratory Science may conduct research or serve on healthcare teams. DCLS work closely with physicians, catching pre- analytical, analytical, and post-analytical test and interpretation errors in order to ensure optimal patient care outcomes. Doctors of Clinical Laboratory Science complete a residency at the end of their training. There are four programs:
Tilidine is used in the form of hydrochloride or phosphate salt. In Germany, tilidine is available in a fixed combination with naloxone for oral administration (Valoron N and generics); the mixture of naloxone is claimed to lower the abuse liability of the opioid analgesic. This is so that if people take the medication orally (which is the way they are meant to) the opioid blocker, naloxone, has minimal effects on them but if they inject it the naloxone becomes bioavailable and hence antagonizes the effects of the tilidine producing withdrawal effects. In Switzerland the original Valoron brand with only tilidine and no naloxone is also available. As well as its use as an analgesic, tilidine is also commonly used in Germany for treatment of restless legs syndrome. The reverse ester is also known and is also a prodrug. Tilidine explicitly without Naloxone is a controlled substance in most countries, listed in the German BtMG, Austrian SMG, and in the USA under the Controlled Substances Act as ACSCN 9750 as a Narcotic under Schedule I, with an annual aggregate manufacturing quota of 10 grams in 2014. It is used as the hydrochloride (free base conversion ratio 0.882) and HCl hemihydrate (0.858).
Sources: en.wikipedia.org
== Etymology == The word analgesic derives from Greek an- (ἀν-, "without"), álgos (ἄλγος, "pain"), and -ikos (-ικος, forming adjectives). Such drugs were usually known as "anodynes" before the 20th century.
The United States has a growing problem with counterfeit drugs. In 2012, tainted steroids killed 11 people near Boston and sickened another 100. In another case, vials of the cancer medicine Avastin were found to contain no active ingredients. The vials were sourced in Turkey, shipped to Switzerland, then Denmark, finally to the United Kingdom from which they were exported to U.S. wholesale distributors. The Wall Street Journal reported that the U.S. wholesale distributor was hired by Canada Drugs, which also owns CanadaDrugs.com, a retail pharmacy website that sells prescription medication internationally, with a focus on the American market. Between 2007 and 2008, 149 Americans died from a contaminated blood thinner called Heparin that was legally imported into the United States. Investigated by the FDA Office of Criminal Investigations, the Albers Medical investigation is the most prolific example to date. In August 2005, the U.S. Attorney's Office for the Western District of Missouri issued a press release announcing that three businesses and eleven individuals were indicted for their involvement in a $42 million conspiracy to sell counterfeit, smuggled and misbranded Lipitor and other drugs and for participating in a conspiracy to sell stolen drugs. As part of this investigation, the FDA initiated a recall of more than 18 million Lipitor tablets, which ranks as the largest recall in the history of criminal investigations of counterfeit medications. Participants in this scheme conspired to purchase and sell counterfeit, misbranded and illegally imported drugs.
While dichloroacetylene is nephrotoxic in rats, its nephrotoxicity in humans is not well-understood. Dichloroacetylene has mutagenic effects on Salmonella typhimurium. Like trichloroethylene, dichloroacetylene is metabolized to S-(1,2-dichlorovinyl)-L-cysteine (DCVC) in vivo. The maximum safe concentration of dichloroacetylene in air is 0.1 parts per million. It is unsafe to store dichloroacetylene in close proximity to potassium, sodium, or aluminium powder. According to the Department of Transportation, it is forbidden to ship dichloroacetylene.
After drug withdrawal, the effects fade away slowly, but may persist for more than 6–12 weeks after cessation of AAS use. Strength improvements in the range of 5 to 20% of baseline strength, depending largely on the drugs and dose used as well as the administration period. Overall, the exercise where the most significant improvements were observed is the bench press. For almost two decades, it was assumed that AAS exerted significant effects only in experienced strength athletes. A randomized controlled trial demonstrated, however, that even in novice athletes a 10-week strength training program accompanied by testosterone enanthate at 600 mg/week may improve strength more than training alone does. This dose is sufficient to significantly improve lean muscle mass relative to placebo even in subjects that did not exercise at all. The anabolic effects of testosterone enanthate were highly dose dependent.
==== The tandem principle ==== The solution emerged from a charge-reversal concept proposed demonstrated by Nobel laureate Luis Alvarez in 1951. Rather than accelerate positive ions from ground to a high-voltage terminal, the tandem accelerator begins with negative ions. These particles accelerate toward a positive terminal, where a thin foil or gas stripper removes multiple electrons, converting them to positive ions. The now-positive particles accelerate away from the terminal back to ground potential. This double acceleration effectively multiplies the particle energy without requiring proportionally higher terminal voltages. A negative hydrogen ion accelerated through a 5 megavolt tandem emerges with 10 megavolts of kinetic energy. After commissioning tandem production in 1954, Atomic Energy of Canada Limited placed HVEC's first tandem order in September 1956 for $0.92M (equivalent to $10.89M in 2025). The machine achieved first beam at HVEC's Burlington facility in June 1958.
Sources: en.wikipedia.org
The mass difference from the linker is large enough for routine detection by mass spectrometry. The unconjugated form gives a single sharp signal at its expected weight. Material that has already reacted with albumin shows a much higher mass and a broadened chromatographic peak.
Yes. Degradation proceeds faster once the powder is dissolved, especially at room temperature or after multiple freeze and thaw cycles. Working solutions are often aliquoted to avoid repeated handling. Lyophilized powder held cold and dry retains its properties far longer.
Truncated sequences, oxidized residues and aggregated forms can all elute near the main peak. Reversed phase chromatography resolves many of these species, so the number of peaks is a useful indicator of synthesis quality. A single peak does not by itself prove correct sequence, which is why mass confirmation is paired with it.
Cool, dark, and dry conditions are standard, with storage at minus twenty degrees Celsius or below. Desiccant and sealed vials limit moisture uptake. Repeated warming and cooling of the container is generally avoided.